Micro Sharpener & Knife Tool

The diamond and ceramic sections are a bit small, but still useful. The idea of sharpener and the most commonly used Torx bits is rather brilliant. If I had control over product development, I’d have a version of the WS field sharpener with a compartment for bits and a cutout to use the body of the sharpener as a handle.

This is handy as all get out. The diamond side will work with esoteric steels and the ceramic works great with more mundane steels. The bits seem okay. I swap them out for some Wihi bits just to be on the safe side. This is all you need in the field if you are comfortable with freehand sharpening.

I have three of these. Keep one in my bag, one in the car and one in my bedside table. For quick edge maintenance, it’s great. Not much use for such a low grit diamond side, it the ceramic side and the torx drivers are a life saver! Great tool. Thanks Worksharp!

Two bits failed, first use. I'm a HUGE Work Sharp fan and owner. I got this because it had EVERYTHING i needed for my Kershaw 1776BLK, which is my EDC knife. Love the sharpener, works amazing and it's going in my fishing bag. However, two of the 3 bits failed on me in use. Sure, over-tightening you say. After i bent the small and medium bits (please email me for pictured Work Sharp) i went and got my in-lbs torque wrench. I don't know where your bits broke, but i was able to tighten to the factory 12 in-lbs of torque with no issue and it was more than a quarter turn to get there. Find a new bit manufacturer please